Post about using Inkscape with cutters or plotters.
2 posts • Page 1 of 1
For use on a laser engraver. Once I finish tracing the bitmap, creating path, and using the laser engraver plugin the end result shits up a few inches. Any ideas what is causing this?
- Screen Shot 2017-02-12 at 10.52.53 PM.png (74.86 KiB) Viewed 729 times
Maybe there's something about this in the forum for gcodetools? http://www.cnc-club.ru/forum/viewtopic.php?t=35
Who is online
Users browsing this forum: No registered users and 2 guests