Hi, I actually build an Eggbot but have serious problems to get it running. For me it seems that inkscape is unable to connect to my eggbot.
Inkscape Version 0.91 (reinstalled after Trials with 0.92.2/4)
eggbot_250 Extension modified eggbot_scanwin32: hKey = _winreg.OpenKey( hReg, r"SYSTEM\CurrentControlSet\Enum\USB\VID_2341&PID_0043" )
"Arduino Uno": ELEGOO UNO R3 IDE 1.8.8
I already tested the Steppers and St-Drivers on the bread board: working and diods showing light/flashes. the same with the servo.
with inkscape: nothing happens: no toggle, no board info, no Motor Walking or pen rising.......dead!
Can anyone help me. Any advise is highly appreciated.
thanks and regards, hannes
Post about using Inkscape with cutters or plotters.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests